FAQ
How do I pair my Mega Grave Digger?
To connect your controller, first turn on the vehicle, then place the batteries in the controller and turn on the power switch. Make sure you hold the controller close to the truck and push up on the left throttle. The light on the remote will turn solid green once it is connected. If your controller isn’t pairing with your truck, turn the remote off by pressing the green power switch, turn off the truck, and restart the pairing sequence. Remember to look for the light on the remote to go solid to ensure the truck and remote are connected. Always make sure your truck is fully charged and the batteries are fresh.
How do I charge my Mega Grave Digger?
- Turn the vehicle off.
- Remove the cover from the charging cable compartment.
- Plug the charging cable into a computer or wall adapter. Only connect USB charging cable to a computer or other 5VDC rated power source.
- Headlights indicate charging. Blinking for charging and ON when fully charged.
What if my Mega Grave Digger is not turning on?
- Charge the Mega Grave Digger until the headlights stop blinking and remain ON.
- Please ensure the vehicle is turned OFF while charging.
What if my Mega Grave Digger is not connecting to my controller?
- Turn the vehicle off and remove batteries from the controller
- Push the throttle up and down to drain any remaining power after batteries are removed
- Turn on the truck
- Insert batteries into the controller
- Push the throttle lever up to the maximum position for approximately 3 seconds and back to minimum position to complete the connection
- The wheels should turn to the right and return back to confirm pairing is successful